casino plus free 100

List of contents of this article:

• 1,casino plus free 100 How to apply the body film of the car?
• 2, car The method of filming andStep
• 3, positive How to apply it

How to apply the body film of the car?

There are two ways to apply body film. The first is dry pasting and the other is wet pasting. Dry pasting method Dry pasting method is suitable for motorcycles, small cars or small areas of film.

Cut the film: According to the size and shape of the vehicle, use scissors or an art knife to cut the film into the appropriate size. It should be noted that the size of the film should be slightly larger than the window or hood to facilitate fitting.Film: Apply the film to the car body and use a plastic scraper to scrape the film flat to ensure that there are no bubbles and wrinkles.

Leave a distance of 5-10mm above the glass and stick the film surface to the car glass to fix it. At this time, do not spray water, and fix the film with tape. If the film is cut slightly larger, the excess film should be cut off while avoiding scratching the glass. Generally, 2-3 cm should be left around it and then finely cut.

Steps for car film: cut the car film according to the size of the car window; wipe and clean the front and rear window glass; use a baking gun to shape the car film; finely cut the car film after the baking film is completed.

How to apply the reflective film in the car? Car reflective film pasting method: First of all, the car body needs to be cleaned, and it is best to spray diluted detergent on the cleaned body.After the cleaning work is completed, it is necessary to determine the car reflective film in the position that needs to be arranged.

Methods and steps for car film

1. Steps for car film: tailor the car film according to the size of the car window; wipe and clean the front and rear window glass; use a baking gun to fix the car film; after the baking film is completed, the car film Just cut it finely.

2. Film cutting: Measure the car glass to be constructed, accurately measure the size of the car window, and cut the exact shape of the car window according to the measured size. If the cutting is not good, it will directly affect the effect and beauty of the film.

3. Sticking a film on a car is something that many car owners have to do, but some car owners want to buy a car film to paste by themselves, but they don't know how to stick it.Next, let's take a look at the correct way to apply car film. Before applying the film to the car, first of all, measure the size of the window and cut the film according to the measured size.

4. Car film application steps: car film pasting (1) Paste the fixed car film on the inside of the glass. When pasting, tear off the plastic of the car film gasket. At the same time, spray the glue surface and glass with pure water, which can reduce the stickiness of the glue and easily remove the adhesions adsorbed by static electricity.

5. Car filming is a difficult technical work, and the process of filming will also affect the final effect; some car owners have strong hands-on ability, and the tools are complete, so they will choose to apply the film by themselves.

The correct pasting method of the car film

Tear open the film, spray water evenly on the effective film surface, and put the torn plastic film aside for later use.

The specific steps of car film are as follows: external cleaning, move clockwise along the car (starting from the "1 o'clock" position, the position of the passenger's front side door), the outer surface of each glass should be thoroughly cleaned, the potential dust should be controlled to a minimum extent, and each glass should be slightly lowered to scrub the top of the glass. Department, because there is more dust there.

Step 1: Fill the sprayer with water first. You can add a few drops of detergent or water appropriately. Step 2: Spray water on the first car glass. Step 3: After spraying water, it is to cut the approximate size of the film first.

The correct way to apply car film is 5 steps: wash the car, measure the size, apply the film, shape it, and check for bubbles.