Arena Plus login

How to change the engine belt Engine belt is Arena Plus loginpart of the vehicle transmission system, which connects the crankshaft of the engine and other Drive parts. The function of the belt is to enable the car's engine to drive various parts of the vehicle, such as pumps, generators, air conditioning compressors and fans. If the belt is worn and cracked, it will cause the transmission between the parts to not be carried out normally, so it is important to replace the engine belt. The following will introduce how to replace the engine belt. Preparations require some basic tools and materials before replacing the engine belt, including: · New engineBelt · Wrench · Phillips screwdriver · Flashlight · Maintenance Manual Step 1: Check the belt. Before replacing the belt, you need to first check whether the belt of the car needs to be replaced. If the belt is found to be cracked, broken or worn, it needs to be replaced in time. In addition, if you find that the belt is loose or does not rotate smoothly, it also needs to be replaced. Step 2: To find the wheel, you need to find the pulley, which usually requires opening the hood. The belt is connected to the crankshaft and then passes through other driving parts transmitted from the crankshaft torquer. It is necessary to make sure that the engine rotor rotates on the wheel and the belt is not stuck or twisted. Step 3: Remove the wheel. When replacing the belt, you need to remove the wheel. The specific practice is to use the tools and methods listed in the vehicle maintenance manual. It should be noted that some wheels may need to use a special tool cart to be disassembled, so you need to be careful during operation.Step 4: Remove the old belt and install the new belt. Untie the original belt with a wrench, and then remove it. Pay attention to observe the direction of the new belt and make sure it is connected to the correct rheel. Pull the new belt into place and check again whether the direction is correct to make sure it is in the right position. Step 5: After installing a new belt on the fixed wheel, the wheel needs to be re-fixed. It is necessary to operate according to the method in the maintenance manual to ensure that all parts are in the correct position. Step 6: After installing the belt, you need to check whether all the parts are inserted in the correct position. Then it is necessary to check whether the belt is attached to all the wheels and ensure that the tension of the belt is appropriate. Finally, you need to start the engine and observe whether it is running normally. Precautions: Replacing the engine belt is a relatively dangerous maintenance work and needs to be very careful.During the operation process, please pay attention to the following precautions: · If you are not sure how to operate, please find the relevant maintenance manual or consult a professional car maintenance technician first. · Please wear appropriate safety equipment, such as goggles and gloves, when operating. · Do not operate when the engine is running. · Do not press hard on the belt to avoid damage to the belt. · Check the tension of the belt to ensure proper installation. Conclusion Although replacing the engine belt requires some technology and tools, the maintenance work can be completed smoothly by following the above steps and precautions. After replacing the engine belt, the belt needs to be checked and maintained regularly to ensure that it is always in the best working condition, which can extend the life of the belt and ensure the safety performance of the vehicle.

Contact Us
Phone：020-83484608